Drill 1/16“ hole through wall ( about 5 1/2“ above floor).  Cut plug off lamp.  Feed wires through hole and glue lamp to outside of house. Cut wire to 1“ longer than needed to reach tapewire. Strip about 3/4“ of insulation from end of  wire (use fingernail and thumb).  Poke hole in each copper strip of tapewire using pushpin. Insert end of wire into hole (one in each).  Insert small eyelet or brad into hole with wire. Only push it about ½ way in. Wrap the rest of the bare wire around eyelet. Hammer the eyelet the rest of the way in. Run a strip of tape over the wire to hold it to the wall.